Industry and Consumer Electronics Solutions:

This is space-saving AC load device where power can be reused.

This is an equipment to handle AC (inverter, UPS) load test. With comparisons to a load device which contains passive components such as resistance and reactor, the installation space is significantly reduced.

Characteristics

• Setting of simulated power factor of LCR load. Go-and-Delay function during Constant Current (CC) mode.
• Equipped with a wide range of load mode such as constant current (CC) mode, constant resistance (CR) mode, constant active power (CP) mode, constant reactive power (CQ) mode and 5 modes of arbitrary waveform generation mode.
• Through an application software (sold separately) on a communication function standard, pattern operation is possible. The computer will be able to read the various parameter settings and status.

Merits

• A smaller and lighter equipment which can be connected in parallel to increase capacity
• Besides her small capacity, the circulation of regenerated electric power is possible in smaller test facilities (power plants and buildings)
• Reduction of electricity cost by effectively using low cost power

Applications

• As an inverter current test load for industrial servo driver and current test load for an electric vehicle inverter
• As a load for power module current test, for example as a R, L, C load for power module current test. The user doesn't need to worry about the heat generation from load during high power current test
• Motor generator evaluation and test load. As a motor generator evaluation and test load. For example, evaluatin and current test for PM motor used in windmill generators and electric vehicles
• As a simulated load of power conditioner. The equipment can be used as a simulated load to be connected to the power conditioner solar power. Reactive power is absorbed and hence not necessary to switch to the load

Reference specifications